Pro Pro is active in this browser. Open your Pro accountPro free trial is active. Open your Pro accountPro is active but will not renew. Open your Pro account

Online Violin, Viola and Cello Tuner

A violin tuner app that needs no install: press Start, allow the microphone and bow an open string. The tuner finds which string it is, shows how many cents sharp or flat, and ticks it off when it holds in tune.

Free · runs in your browser · nothing is uploaded

Open on Tonelume

This embed was switched off for this website. Open on Tonelume

Add this tool to your siteFree embed code, no sign-up. Keep the credit link.

Embed this tool

Copy this code into your website, blog or class page. The tool runs inside your page.

Optional settings, added to the address after embed=1: &accent=0f6b5c (colour, 3 or 6 hex digits). Other parameters are ignored.

Please keep the credit link below the tool.

This free violin tuner listens through your microphone and tells you which open string you played and how far it is from the right pitch. Choose Violin (GDAE), Viola (CGDA) or Cello (CGDA), bow one string and the tuner finds the closest string, shows the note and moves the needle. The needle sits in the green zone within 5 cents; hold it there for about half a second and the string is checked off.

It runs in your browser with no sign-up and nothing is recorded or uploaded. Orchestras often tune a little above 440 Hz, so the Calibrate box accepts any A4 from 415 to 466 Hz.

How to tune a violin, viola or cello

  1. Choose your instrument. Violin strings are G D A E; viola and cello are C G D A, the viola an octave above the cello.
  2. Start the tuner. Press Start tuner and allow the microphone. Hold the instrument a few inches from the device.
  3. Start with the A string. Bow it with a long, even stroke near the middle of the string and let it sound for a second.
  4. Read the needle. Left of the middle means flat, so tighten; right means sharp, so loosen. Use the fine tuners for small corrections and the pegs only for big ones.
  5. Tune the other strings one at a time, then check the A again. Violin and viola players often tune the other strings to each other in fifths once the A is right.
  6. Pizzicato works too. Plucking gives a clear pitch, but bowing is steadier for the reading.
  7. Other pitch? Change A4 in the Calibrate box, for example 442 for many orchestras or 415 for baroque music.
  8. Cello and viola players should bow slowly: low strings need a longer stretch of sound before the tuner can read the pitch, so give each string two or three seconds.
  9. New strings or a cold room? Strings stretch for days and move with temperature. Tune again after the instrument has settled in the case or on the stand for a few minutes.

Open strings of the violin family

Frequencies are for A4 = 440 Hz and come from the same table the tuner uses.

InstrumentStrings (low to high)Hz at A4 = 440
Violin (GDAE)G3 D4 A4 E5196.0 293.7 440.0 659.3
Viola (CGDA)C3 G3 D4 A4130.8 196.0 293.7 440.0
Cello (CGDA)C2 G2 D3 A365.4 98.0 146.8 220.0

Violin, viola and cello are all free. Tunings are fifths: each string is a perfect fifth (7 semitones) above the one before it. If your strings are tuned in perfect fifths and the A is right, the others follow. A perfect fifth is the interval in which two notes blend so closely that a small error shows up as a slow, wobbling beat, which is why players tune by ear against the neighbouring open string as well as by the needle. The cello and viola share note names but sit an octave apart, so the page switches the target frequencies when you pick the instrument.

How the check marks work

Each string button fills with a tick once the pitch has stayed within 5 cents for about 0.6 seconds, and the tick stays while you tune the other strings. Changing the instrument or the A4 value resets the ticks because the target notes move. The graph under the strings draws the last six seconds, so you can watch a bowed note settle toward the middle line as you turn the fine tuner. Because the engine hears from C2 up to E5 and above, the same page works for all three instruments.

What does “cents” mean?

A cent is one hundredth of a semitone. Players sense pitch differences of about 5 to 10 cents, especially in fifths, so the green zone is 5 cents wide on each side.

Why does the reading flicker on a bowed string?

A scratchy or very light bow adds noise, and the first moment of a bow change is not a clean pitch. The tuner takes the median of the last five readings and ignores unclear frames. Use a steady bow with even pressure and let the note sustain.

Frequently asked questions

How do I tune a violin with the microphone?

Press Start tuner, allow the microphone and bow the open A string, then the others. The needle shows flat or sharp; adjust until the note turns green and the string is checked off.

What are the violin strings?

G3, D4, A4 and E5, from the lowest to the highest. The notes are spaced a fifth apart.

Does it work for viola and cello?

Yes. Choose Viola (CGDA) or Cello (CGDA). The viola is an octave above the cello.

Can I tune to 442 Hz or baroque 415 Hz?

Yes. Type the A4 you need in the Calibrate box. Values from 415 to 466 Hz are accepted and saved in your browser.

Which string do I tune first, and is it free?

Start with the A, then the D, G and E, and play the A again at the end because moving the other strings changes the tension on the bridge. The tuner is free: no account and no time limit for violin, viola and cello. Strobe view and a tuning history are Tonelume Pro features.

Does the tuner record my sound?

No. The microphone stream is analysed in your browser on a live basis; nothing is saved or sent. When you press Stop or leave the page the microphone is released.

Can I change the reference pitch?

Yes. Type any value from 415 to 466 Hz in the Calibrate box or use the plus and minus buttons. The strings, reference tones and readings follow, and the setting is saved in your browser.

Why does it say it cannot use the microphone?

Your browser blocked it. Allow the microphone for this site in the address bar and press Start again. The reference notes work without a microphone.