Pro Pro is active in this browser. Open your Pro accountPro free trial is active. Open your Pro accountPro is active but will not renew. Open your Pro account

Online Chromatic Tuner

Press Start, allow the microphone and play any note. The tuner shows the nearest note, how many cents sharp or flat, and the frequency in Hz.

Free · runs in your browser · nothing is uploaded

Open on Tonelume

This embed was switched off for this website. Open on Tonelume

Add this tool to your siteFree embed code, no sign-up. Keep the credit link.

Embed this tool

Copy this code into your website, blog or class page. The tool runs inside your page.

Optional settings, added to the address after embed=1: &accent=0f6b5c (colour, 3 or 6 hex digits). Other parameters are ignored.

Please keep the credit link below the tool.

A chromatic tuner shows the note closest to what you play, whatever it is, instead of comparing against a fixed set of strings. That makes it work for violin, viola, cello, bass, ukulele, mandolin, banjo, flute, trumpet, saxophone, a voice or a piano key as well as guitar. The needle shows how far the pitch is from the nearest note in cents, and the tuner prints the exact frequency.

It runs in your browser with no sign-up. The microphone sound is analysed on your device and is never recorded or uploaded. For a guitar with string-by-string tuning, use the guitar tuner.

How to use the chromatic tuner

  1. Press Start tuner and allow the microphone.
  2. Play one note and let it ring. The big letter is the nearest note; the number below says how many cents you are off. Flat means too low, sharp too high.
  3. Adjust your instrument until the needle sits in the green middle zone and the tuner says “In tune”.
  4. Check the graph. The line shows the last six seconds. A line that wobbles around the middle is vibrato or an unsteady bow; a flat line in the green band is a steady, in-tune note.
  5. Match another pitch. Change A4 in the Calibrate box when you play with a piano or ensemble that is not at 440 Hz, for example 442 Hz.
  6. Tune several notes in a row. Play each note on its own and wait until the tuner says “In tune” before you move to the next; after the last one, play the first again, because tightening one string or string group shifts the others a little.
  7. Read the trace for steadiness. A note that drifts upward as it rings is a string still settling; pluck again, or let a bowed note find its pitch before you judge it. Singers can use the same trace to see whether a held note stays level.

Note frequencies at A4 = 440 Hz

NoteOctave 2Octave 3Octave 4Octave 5
C65.41 Hz130.81 Hz261.63 Hz523.25 Hz
C#69.30 Hz138.59 Hz277.18 Hz554.37 Hz
D73.42 Hz146.83 Hz293.66 Hz587.33 Hz
D#77.78 Hz155.56 Hz311.13 Hz622.25 Hz
E82.41 Hz164.81 Hz329.63 Hz659.26 Hz
F87.31 Hz174.61 Hz349.23 Hz698.46 Hz
F#92.50 Hz185.00 Hz369.99 Hz739.99 Hz
G98.00 Hz196.00 Hz392.00 Hz783.99 Hz
G#103.83 Hz207.65 Hz415.30 Hz830.61 Hz
A110.00 Hz220.00 Hz440.00 Hz880.00 Hz
A#116.54 Hz233.08 Hz466.16 Hz932.33 Hz
B123.47 Hz246.94 Hz493.88 Hz987.77 Hz

Each step up in the list is one semitone, a factor of 2^(1/12) in frequency; each octave doubles the frequency. Change A4 and all of these scale with it.

How are cents calculated?

A cent is one hundredth of a semitone, so it is a ratio, not a fixed number of hertz: at low notes one cent is a very small frequency step, at high notes a larger one. Most listeners notice an error from about 5 cents when two notes sound together, and an error of 1 or 2 cents is hard to hear at all, which is why a tuner reports cents and not hertz.

Cents = 1200 x log2(your frequency / the note’s frequency). Example: the A4 reference is 440 Hz; a string at 442 Hz is 1200 x log2(442/440) = +7.9 cents, a little sharp. A semitone is 100 cents.

How accurate is the tuner?

We tested the page in a real browser with generated plucked-string tones (overtones plus light noise, the low strings with a weak fundamental) played through a test microphone at known pitches:

Test toneResult (note, cents off)
E2, A2, D3, G3, B3, E4 (standard guitar strings)each string recognised, within 0.1 cents
A4 at 440 HzA4, 0.0 cents
A4 at 442 Hz with A4 = 440A4, +7.8 cents (true value +7.9)
A4 at 442 Hz after setting A4 = 442A4, 0.0 cents, “In tune”

Real instruments add noise, vibrato and decay, so a real string can wobble a few cents; the tuner takes the median of the last five readings to keep the needle steady.

Common instrument tunings

InstrumentStrings, low to high
GuitarE2 A2 D3 G3 B3 E4
Bass guitar (4-string)E1 A1 D2 G2
UkuleleG4 C4 E4 A4
ViolinG3 D4 A4 E5
ViolaC3 G3 D4 A4
CelloC2 G2 D3 A3
MandolinG3 D4 A4 E5
Banjo (5-string, open G)G4 D3 G3 B3 D4

Frequently asked questions

What is a chromatic tuner?

A tuner that recognises all twelve notes of the scale in any octave, not only the strings of one instrument. You play a note and it shows the closest one and how far off you are.

How do I tune an instrument with an online tuner?

Press Start tuner, allow the microphone and play a single note. Tighten or loosen until the note you want is shown and the needle is in the green zone.

Which instruments can I tune?

Any instrument with a clear pitch: guitar, bass, ukulele, violin, viola, cello, mandolin, banjo, wind and brass instruments, and your voice. Drums and noisy sounds have no clear pitch and cannot be tuned this way.

Can I tune to 432 Hz or 442 Hz?

Yes. Set A4 between 415 and 466 Hz in the Calibrate box. 432 and 442 are both in that range. The setting is saved in your browser.

Is the online tuner free and private?

Yes, free with no account. The sound is analysed in your browser and is never recorded or sent. A strobe view and tuning history are part of Tonelume Pro.

Why does the note jump between two values?

Your pitch is close to the boundary between two notes, 50 cents from each. Aim for the note you want and look at the cents, not the letter.

Why does it not react?

Check that the microphone is allowed for this site and that the browser is not using another input. Play louder or closer; very quiet and very noisy sounds are ignored.